Stainless steel tank 15 basic technical requirements
Stainless steel water tank is a new generation of water tank after the glass water tank product, its products are made of SUS304 stainless steel Seiko molded, handsome in appearance, economical and practical, the main body is not bad.
Stainless steel water tank compared with other water tanks, with a light weight, high strength, corrosion resistance, high temperature, clean water, seepage, earthquake, never raw moss, easy installation, no maintenance, easy cleaning and many other advantages
Stainless steel tank 15 basic technical requirements
1 The tank shall comply with the requirements of this standard and shall be manufactured in accordance with the required drawing requirements and dimensions.
2 after the completion of the welding tank after the firmware must not be loose, the joints shall not have leakage welding, no leakage phenomenon.
1.22mm*1.22mm galvanized water tank panel
3 water tank weld to be full, the outer surface of the tank to be smooth, beautiful, no slag, no welding tumor, no pores, no cracks, welding mouth can not split, separation phenomenon, no cutting phenomenon. Water tank liner welds need to be polished.
4 The flat bottom of the tank should be kept flat.
5 The top of the tank and the manhole must be fully welded.
6 water tank connection must be a good welding, while trying to keep vertical, at least the tilt is not greater than 1 °.
7 insulation layer and the appearance of a solid tank, the appearance of flat. Insulation layer with polyurethane foam plastic or better performance of the insulation material; outside the decorative shell with stainless steel or other suitable materials, the surface may not be uneven, there are scratches or rust.
8 for the dimensions to allow tolerances should meet the "stainless steel cold-rolled steel and steel" requirements.
Panel Type Water Tank / Sectional GRP Panel Tank
9 water tank filled with water, shall not have infiltration, leakage phenomenon, there should be no obvious deformation phenomenon, according to the steel welding atmospheric pressure vessel on full water experimental terms. (GB50242-2002 building water supply and drainage and heating construction quality acceptance criteria)
10 should be kept vertical when the tank is erected.
11 The actual water content of the tank shall be not less than the nominal volume.
12 stainless steel used in the tank should comply with the provisions of GB / T3280. Water tank used in the plate must be 304 stainless steel plate. Inside and outside board thickness tolerance is less than 10%.
13 carbon steel used in the tank shall comply with the provisions of GB / T 700. Water tank all iron parts must be anti-corrosion treatment, need to use anti-rust paint to do two anti-rust treatment, exposed to the outer part of the brush twice silver paint.
1m*1m FRP/GRP Panel for SMC water tank
14 tanks inside and outside the protruding parts should be flanging or other protective treatment, to avoid cutting people.
15 clean, the water tank filled with GB5749 provisions of the water, standing 1h, the water tank outlet should meet the requirements of GB5749
For more information, please visit our website: www.grp-watertank.com, or contact us with E-mail, our E-mail address is rask@coolingtowerfiller.com, you can also chat us straightly on whatsapp: 008618330029204, you can also call our boss straightly: 008615930159213
评论
发表评论