Stainless steel fire tank roof installation precautions

1.22mm*1.22mm galvanized water tank panel
      What is the stainless steel fire water tank, that is, with a regulator pump, pressure tank, frequency control pump water supply equipment are temporary high pressure water supply system, and temporary high pressure system should be set to stainless steel fire tank to ensure that the most inverted point indoor fire hydrant and active spray Water rescue system to compensate for the amount of water required before the fire and water pressure, arrived in the active compensation of the early warning of the fire. Thus, in the equipment high-rise building roof stainless steel fire tank when the need to pay attention to several aspects.
Hot-dipped Galvanzied Sectional Water Storage Tanks for Water Treatment
1, stainless steel fire water tank pipe arrangement to be reasonable:
According to the standard requirements, stainless steel fire water tank should be set into the water pipes, outlet pipes, overflow signal tube, ventilation pipes, etc., in order to ensure that the water quality is not contaminated and punctured when the water sediment and impurities, stainless steel fire tank should also set empty The On the outlet pipe diameter, should be based on program flow and flow rate to determine the fire hydrant system, the tank outlet by pressurization (the height of the tank can not be satisfied with the hydraulic accounting requirements), can be directly connected with the fire hydrant pipe network, and On the active water rescue system, must be wet alarm valve, in order to connect with the spray riser, and must not be wet valve directly connected with the pipe network, because the alarm valve on the hydraulic alarm is by water Excited to the police, if not through the alarm valve, the fire, the pressure of water can not enter the alarm channel, resulting in pressure switch, hydraulic alarm does not move, but not agile declared electrical signal recommended spray pump, so that the pipe network Water is not adequately guaranteed. In order to prevent the fire pump opened after the water into the water supply pipe network into the stainless steel fire tank, stainless steel fire water tank on the outlet pipe must also be added to check the valve to prevent water into the stainless steel fire tank and ensure that the fire pump open when the pipe network pressure.
Panel Type Water Tank / Sectional GRP Panel Tank
2, stainless steel stainless steel fire tank pressurization methods to be in place:
       According to the standard requirements, high stainless steel fire tank set height should be satisfied with the system in the most upside down the required water pressure, the most reverse point of the fire hydrant pressure is not less than 7m water column (over 100m when the hydrostatic pressure of not less than 15m water column), the most upside down The working pressure of the nozzle should not be less than 5m water column, if added along the way and some of the head lost, the stainless steel fire water tank water level and the lowest point of the geometric height of at least no less than 20m distribution, which not only affected the building Beautiful, and the structure of the building program and construction also caused a certain degree of difficulty, therefore, located in the top of the high-rise building stainless steel fire tank is usually not satisfied with the most droop fire hydrant or active water spray equipment, equipment. Commonly used equipment is pressure tank or regulator pump. Program, it is assumed that there is no pressurized water on the outlet pipe of the single clear water tank, because there is no water supply in the pipe network. Once the pipe network is leaking, the pressure inside the pipe network will be reduced, Closed again and again, affecting its use of longevity.
1m*1m FRP/GRP Panel for SMC water tank
On the use of air supply alone program, there are many in the internship project. Under normal circumstances, by a small pressure tank to adhere to the pipe network pressure, the water storage from the main role of leakage, the pump for the small flow, low head. Pump proposal, the roof of the water tank in the water pipe, the pump into the fire pipe network, together, some water into the booster tank, the pressure gauge on the tank to control the pump opening and closing. Because the system has a scheduling of water, to prevent the pump again and again. Its equipment structure is relatively simple, small footprint, and in the absence of electricity, but also to save water.
Fire water storage tanks
For more information, please visit our website: www.grp-watertank.com, or contact us with E-mail, our E-mail address is rask@coolingtowerfiller.com, you can also chat us straightly on whatsapp: 008618330029204, you can also call our boss straightly: 008615930159213